It has arrived! Click here to download the latest firmware. This update fixes time handling issues that were present when power to the fixture was interrupted.
Please note, this is ONLY for the Wifi edition, do not use this firmware on your Non Wifi Powermodule.
Step 1: Download
Download the file linked above. Unzip it. Then, save it to a location on your computer where you will be able to find it easily.
Step 2: Save Your Current Program
When you update your firmware, the fixture is reset to factory-default settings. Prior to installing the update, please save your fixture’s program to your computer. Do this by selecting the “Download” option from the File menu. (File > Download)
Save the file in a convenient place, so you will be able to retrieve it easily once you have updated the firmware.
Step 3: Update Your Firmware
After your light program has been saved, install the firmware. In your fixture’s menu, go to Settings > Firmware-Update. Use the “Choose File” button to select the update you saved to your computer, and click “Run.”
Step 4: Setup Your Fixture
It may take a few minutes for the firmware update to be installed on your fixture. Once it has been completed, proceed through the basic fixture setup procedure. The quick start guide for the Wifi LED Powermodule is below, in case you need to reference the steps.
Step 5: Reload Your Program
After setup is complete, use the File menu to reload your saved light program to the fixture. Make sure to use the “Save” option when the program is displayed on your screen to save the program to the Powermodule.